Taylormade R11 Driver wholesale golf clubs 20110222

Taylormade R11 Driver

The three shortcomings of the original shaft is destined to the limitations of its application. When a golfers swing technique over the original shaft design limits, the club will begin to affect the results. For example, a golfers swing speed over 100MPH, if you use the original shaft, even if it is TaylorMade R9 TP Irons currently the most hard to buy into S, the same will be the right regular starter, and will seriously affect the distance. If you swing faster than 100MPH, kick-off when using the original shaft opened well, and that unfortunately, the Friends of the swing the ball has been limited by the shaft, without realizing it may be forced to correct himself before into the wrong swing. Golfers use custom clubs try to play the original production in the clubs, they often will encounter scattering rate, the deviation of the ball and so unconventional, these situations are often caused by the improper shaft of . TaylorMade R9 SuperTri Driver

Second, the principle of energy transfer shaft

The energy generated during the swing for the swing of the people is more stable. How to put this energy to pass as much as possible through the shaft TaylorMade R9 Max Irons to the shaft head is never-ending pursuit of R & D personnel.

Shaft in the swing process, the most important role is to transfer energy. The better of the shaft, the more raw materials used in advanced research and development cycle, the longer the more expensive price, the stronger the ability of energy transfer.Taylormade R9 Max Driver

In the initial stage of rod, club head speed gradually accelerated, but not enough to generate the power shaft bending (load), this time, almost no energy is wasted.

Vertex in the bar, the moment the club is relatively static, with the start bar in the process, the body began to produce the most powerful transmission shaft. As head of the heavy weight, so the head was left behind in the shaft (lag), lead shot was seriously start bending force (load). Bend in the shaft at the same time, the shaft began to deformation (deformation). The impact of the ball near the (impact) of the moment, hand to complete the release (release) action, the shaft began to recover. Will carry the energy release. In this aspect, to show the performance of the shaft. Shaft deformation using high-end materials, small, resilient, good stability, with a strong rebound (KICK), while the ordinary shaft deformation, recovery is weak, poor stability, low rebound (KICK). This is the high-end shaft can pass more energy the main reasons. ooobgolfclubs wholesale golf clubs

Third, the definition of hardness oobgolfclubs

Taylormade R11 Driver